Skip to content

Integrated Circuits

Interface ICs — RS-485, RS-232, CAN

RS-485/RS-422 transceivers, RS-232 drivers, CAN and CAN-FD transceivers, plus isolated variants and USB-UART bridges.

Specifying Interface IC without a costly substitution

Interface transceivers are specified by the bus they survive, not the bus they drive. ESD rating, common-mode range, fail-safe behaviour and isolation voltage decide whether a node keeps working when a cable is plugged in live or a ground potential difference appears across a long run.

We quote RS-485 parts by duplex, data rate, common-mode range, ESD level and package. Isolated transceivers are quoted with the isolation rating and the certification that goes with it, because an "isolated" part without a recognised rating is not a safety component.

CAN transceivers are increasingly platform-specific: the same SO-8 outline may be a classic CAN part, a CAN-FD part, or a partial-networking variant. We confirm the exact suffix before quoting, since a wrong variant can leave a node silent in a network that otherwise looks healthy.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
BusesRS-485/RS-422, RS-232, CAN, CAN-FD, LIN
Data rateUp to 50 Mbps (RS-485), 8 Mbps (CAN-FD)
ESD±8 kV to ±30 kV contact, series dependent
Isolation2.5 kV – 5 kV RMS on isolated variants
PackagesSOP-8, SOIC-14/16, DFN, SOICW-16
ExtrasHalf/full duplex, fail-safe, ±60 V fault protection

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Industrial fieldbus nodes
  • Motor drive communication
  • BMS and charger CAN links
  • Legacy serial ports
  • Isolated multi-drop networks
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
MAX485ESA Analog Devices SO-8 RS-485 half duplex 500 pcs Seen in market

Questions buyers ask about Interface IC

Which ESD level should I specify?

Match it to the connector exposure. A board inside an enclosure has a different requirement from a panel-mounted port. We quote the ESD class explicitly so it can be compared with your test plan.

Are isolated parts certified?

Only the series with a recognised safety certificate are quoted as isolated. We will provide the certificate reference; an unmarked "isolated" part is not offered for mains-adjacent use.

Can you confirm CAN-FD support?

Yes, by exact suffix. Classic CAN transceivers will pass a low-rate FD frame in a bench test and fail in a loaded network, which is why we do not treat the family as one part.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.