Skip to content

Integrated Circuits

Op-Amps & Comparators

General-purpose, precision, low-noise and rail-to-rail op-amps and comparators in single, dual and quad configurations.

Specifying Op-Amp / Comparator without a costly substitution

An op-amp substitution fails on the parameters nobody put in the comparison table: input bias current, offset drift over temperature, slew rate, and stability into a capacitive load. Two parts with the same GBW and the same SO-8 footprint can behave completely differently in a transimpedance stage.

We quote by channel count, supply range, input and output swing, offset voltage and drift, GBW, and package. Precision parts are binned by offset and drift, and we quote the bin rather than the family, because that is what the design was compensated for.

Comparator requests usually come with a specific response time and output type — open-drain versus push-pull changes the pull-up and the logic level. We confirm both before quoting, since the same family often contains both variants under adjacent part numbers.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
ChannelsSingle, dual, quad
Supply1.8 V – 36 V; dual-supply variants available
Offset1 µV – 10 mV, drift specified per grade
GBW10 kHz – 100 MHz
OutputRail-to-rail, push-pull, open-drain (comparators)
PackagesSOT-23-5, SOP-8, MSOP, DFN, TSSOP-14

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Sensor signal conditioning
  • Current sensing amplifiers
  • Active filters
  • Threshold detection
  • Audio and instrumentation front ends
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
LM358DR Texas Instruments SO-8 dual op-amp 2,500 pcs Seen in market

Questions buyers ask about Op-Amp / Comparator

Can I substitute a faster op-amp?

Not without checking stability and input bias. A faster part with the same footprint often oscillates in a circuit compensated for the original. We will quote alternatives and state the parameters that changed.

Do you supply precision grades with drift data?

Yes, quoted by grade. If the grade is not available we will not silently ship the standard part — the drift difference is exactly what the design budget assumed away.

Are the parts genuine?

Op-amps are heavily counterfeited in this market. Every order goes through marking and date-code inspection, and critical lines can be decapsulation tested by a third-party lab.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.