Skip to content

Wire, Thermal & Mechanical

Thermal Pads, Heat Sinks & Interface Material

Gap pads, thermal grease, phase-change material, adhesive tapes and extruded or die-cast heat sinks for power and LED assemblies.

Specifying Thermal / Heat Sink without a costly substitution

Thermal interface material is specified by thermal conductivity, thickness and — the number that actually matters — the pressure it will see in the assembly. A 3 W/m·K pad compressed to 30% performs differently from the same pad left at nominal thickness, and a pad that is too thick to close the gap is worse than grease applied properly.

We quote gap pads by conductivity, thickness and hardness (Shore 00), grease by conductivity and viscosity, and phase-change material by transition temperature. Heat sinks are quoted by extrusion profile, dimensions, finish and attachment method, with the thermal resistance stated at a defined airflow rather than as a single headline figure.

For production assemblies the mechanical stack — board flatness, screw torque, pad compression — decides the result more than the material datasheet. We will quote the material and state the compression it is rated for, but we do not claim a junction temperature without the assembly drawing.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
Pads1 – 8 W/m·K, 0.3 – 5 mm, Shore 00 20 – 60
Grease1 – 6 W/m·K, low bleed and high-viscosity grades
Phase change45 – 60 °C transition, 0.1 – 0.3 mm
TapeThermally conductive double-sided, 0.1 – 0.5 mm
Heat sinksExtruded aluminium, die-cast, skived fin, with clips or screws
FinishMill, anodised, black oxide, nickel on request

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Power device to heat sink
  • LED board thermal path
  • Battery pack gap filling
  • Enclosure heat spreading
  • Fan-less industrial designs
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
HS-ALU-25x25x10 Generic 25×25×10 mm anodised 500 pcs Seen in market

Questions buyers ask about Thermal / Heat Sink

Pad or grease?

Grease for thin, well-machined interfaces under pressure; pads for uneven gaps and assembly simplicity. Pads cost more but remove the dispensing step and the mess.

What compression should I design for?

Check the material rating — most pads are specified at 20–40% compression. Too little contact means poor transfer, too much can crack the die or lift the pad.

Can you supply custom heat sinks?

Yes, from a drawing or a 3D file, with the profile and attachment quoted. Tooling applies to new extrusions, so using an existing profile is usually much cheaper.

More in Wire, Thermal & Mechanical

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.