Skip to content

Wire, Thermal & Mechanical

Wire Harnesses & Cable Assemblies

Crimped harnesses, terminal leads and cable assemblies made to drawing, with connector, wire gauge and test report specified.

Specifying Harness / Cable Assembly without a costly substitution

A harness is only as good as its crimp. A correct terminal on the wrong wire gauge, or a crimp height set for a different insulation thickness, produces a joint that passes a pull test at the bench and fails after a few thermal cycles. The drawing has to specify the terminal, the wire, the crimp height and the pull-test value, not just the length.

We coordinate harness builds in partner assembly houses: cut, strip, crimp, solder, overmould, sleeve and label, with continuity and pull-test reports on request. Connector brand and terminal part number are quoted explicitly, because substituting a connector family changes the mating half and often the retention force.

Made-to-order harnesses carry tooling and minimum quantities for anything with a custom overmould or a new terminal applicator. Standard terminal leads — the common 2.54 mm and JST-style pigtails — are available in smaller quantities and are the practical choice for prototypes.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
Wire gauge32 – 10 AWG (0.03 – 6 mm²)
InsulationPVC, silicone, PTFE, XLPE
TerminalsCrimp, solder, IDC; ring, spade, ferrule, pin
ConnectorsJST, Molex, TE, Hirose equivalents and originals
TestingContinuity, pull test, hipot on request
OptionsSleeving, braid, overmould, labelling, harness board build

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Appliance and equipment internal wiring
  • Battery pack leads
  • Sensor and actuator looms
  • Control panel wiring
  • Prototype pigtails
Sourcing note. Harnesses are built to drawing. Tooling, minimum quantity and sample approval set the timeline — availability on this page describes capability, not shelf stock.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
JST-XH-4P-300 JST XH 4-pin, 300 mm, both ends 200 pcs Made to order

Questions buyers ask about Harness / Cable Assembly

What do you need to quote a harness?

A drawing or a photo with the connector part numbers, wire gauge, length and stripping dimensions. Without the terminal part number the quote is a guess, and guesses become rework.

Do you provide test reports?

Continuity and pull-test reports are available on request and quoted with the job. For safety-related assemblies we recommend hipot testing as well.

Are the connectors original?

We quote the brand you specify. If an equivalent is proposed it is marked as such, because a connector substitution changes the mating half and the retention force.

More in Wire, Thermal & Mechanical

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.