Skip to content

Sensors & Modules

Current & Voltage Sensors

Hall-effect and shunt-based current sensors, isolated transducers and voltage sensing modules for motor drive, BMS and power supplies.

Specifying Current / Voltage without a costly substitution

Current sensing splits into two philosophies. A shunt plus amplifier is accurate and cheap but brings isolation problems; a Hall or fluxgate sensor isolates by construction but drifts with temperature and needs care around external fields. The right choice depends on the bus voltage and on whether the measurement must survive a fault.

We quote by measurement range, isolation voltage, output type (analogue, digital, PWM), accuracy and bandwidth. For BMS and inverter applications the isolation rating and the creepage distance are safety parameters, not marketing ones, and we quote the certified series only.

Voltage sensing follows a similar pattern — resistive divider plus isolation amplifier, or an isolated transducer. Where a design needs both current and voltage on the same phase, we quote the pair so the isolation scheme is consistent rather than assembled from two unrelated parts.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
TypesHall effect, shunt plus amplifier, fluxgate, isolated transducer
Range±1 A – ±1,000 A
IsolationBasic and reinforced, up to 5 kV RMS
OutputAnalogue voltage/current, digital, PWM, SPI
BandwidthDC – 200 kHz, part dependent
PackagesSOIC-8, SOIC-16, module, split-core transducer

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Motor phase current sensing
  • Battery management systems
  • Inverter and PFC current loops
  • Overcurrent protection
  • Energy metering
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
ACS712ELCTR-20A-T Allegro SOIC-8 Hall 20 A 500 pcs Seen in market

Questions buyers ask about Current / Voltage

Shunt or Hall — which should I use?

Below about 60 V, a shunt with an isolated amplifier is usually more accurate for the price. Above that, or where galvanic isolation is mandatory, a Hall or fluxgate part is the practical choice.

Are the isolation ratings certified?

The series we quote for mains and traction use carry recognised certification and we provide the reference. Uncertified "isolated" sensors are not offered for those applications.

Can you supply split-core transducers?

Yes, in module form for retrofit metering. They are quoted as a separate line with accuracy class stated, since retrofit accuracy depends on the installation as much as the part.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.