Skip to content

Sensors & Modules

Optocouplers & Photoelectric Sensors

Transistor and logic-output optocouplers, high-speed and gate-drive types, plus reflective and through-beam photoelectric sensors.

Specifying Optocoupler / Photoelectric without a costly substitution

An optocoupler is specified by current transfer ratio, isolation voltage, speed and CTR degradation over life. The CTR bin decides whether a circuit designed around a 100% part will still switch at end of life with a 50% one, and the bin code is a separate ordering line even though the marking looks similar.

We quote transistor-output, logic-output, high-speed and gate-drive optocouplers by CTR bin, isolation rating, speed and package. For gate-drive parts the propagation delay and common-mode transient immunity are the parameters that matter, and they are the ones most often left out of a comparison table.

Photoelectric sensors — reflective, through-beam and slot types — are quoted by sensing distance, output type and housing. In dusty or outdoor installations the sensing distance in the datasheet is optimistic, so we quote a part with margin rather than the smallest one that fits the drawing.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
TypesTransistor output, logic output, high-speed, gate drive, photovoltaic
Isolation2.5 kV – 5 kV RMS
CTR20% – 600%, binned
SpeedUp to 50 Mbaud (high-speed series)
PhotoelectricReflective, through-beam, slot; 5 mm – 30 m range
PackagesDIP-4/6/8, SOP-4/5, wide-body SO-6, M12 housings

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Isolated signal transfer
  • IGBT and MOSFET gate drive
  • PLC input isolation
  • Position and presence detection
  • Mains zero-cross detection
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
PC817X2NSZ0F Sharp DIP-4 phototransistor 2,000 pcs Seen in market

Questions buyers ask about Optocoupler / Photoelectric

Does the CTR bin really matter?

Yes. A circuit designed for a 100% CTR part can fail to switch with a 50% bin at low LED current. We quote the bin, and we flag when only an unlabelled generic part is available.

Can I use a general optocoupler for gate drive?

Not for a switching converter. Gate-drive parts are specified on propagation delay, skew and common-mode transient immunity; a general-purpose part will work on the bench and fail under dv/dt.

Do you supply wide-body parts for mains isolation?

Yes, with the certification reference. The wide-body package is a safety requirement, not a packaging preference.

More in Sensors & Modules

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.