Wire, Thermal & Mechanical
Thermal Pads, Heat Sinks & Interface Material
Gap pads, thermal grease, phase-change material, adhesive tapes and extruded or die-cast heat sinks for power and LED assemblies.
Typical specifications
Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.
| Parameter | Range we source |
|---|---|
| Pads | 1 – 8 W/m·K, 0.3 – 5 mm, Shore 00 20 – 60 |
| Grease | 1 – 6 W/m·K, low bleed and high-viscosity grades |
| Phase change | 45 – 60 °C transition, 0.1 – 0.3 mm |
| Tape | Thermally conductive double-sided, 0.1 – 0.5 mm |
| Heat sinks | Extruded aluminium, die-cast, skived fin, with clips or screws |
| Finish | Mill, anodised, black oxide, nickel on request |
Where it is used
Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.
- Power device to heat sink
- LED board thermal path
- Battery pack gap filling
- Enclosure heat spreading
- Fan-less industrial designs
Part numbers on the desk
Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.
| Part number | Brand | Package | MOQ | Availability |
|---|---|---|---|---|
| HS-ALU-25x25x10 | Generic | 25×25×10 mm anodised | 500 pcs | Seen in market |
Questions buyers ask about Thermal / Heat Sink
Pad or grease?
Grease for thin, well-machined interfaces under pressure; pads for uneven gaps and assembly simplicity. Pads cost more but remove the dispensing step and the mess.
What compression should I design for?
Check the material rating — most pads are specified at 20–40% compression. Too little contact means poor transfer, too much can crack the die or lift the pad.
Can you supply custom heat sinks?
Yes, from a drawing or a 3D file, with the profile and attachment quoted. Tooling applies to new extrusions, so using an existing profile is usually much cheaper.
More in Wire, Thermal & Mechanical
Next step
Send the part number. We will check the booths.
One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.