Skip to content

Power & Discrete

Diodes — Schottky, Fast Recovery & Rectifier

Schottky, ultrafast recovery, standard rectifier and Zener diodes in SMD and through-hole packages, quoted with Vf and recovery time.

Specifying Diode without a costly substitution

Diode choice comes down to forward drop against recovery behaviour. Schottky parts have low Vf and effectively no reverse recovery, but leak more at high temperature and top out around 100–150 V. Fast recovery parts handle higher voltage at the cost of recovery loss. Choosing between them is a converter topology question, not a price question.

We quote rectifiers by Vrrm, If(av), Vf at rated current, trr and package, plus the thermal resistance that decides whether the part survives in a small SMD footprint. Zener and TVS-like clamps are quoted by voltage tolerance and power dissipation.

Small-signal diodes and common rectifiers are genuinely stocked by the reel and are the least risky category to buy from the market. High-current stud-mount and press-fit parts are the opposite: few sources, and the thermal interface matters as much as the silicon.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
TypesSchottky, ultrafast, standard, Zener, small-signal switching
Vrrm20 V – 1,600 V
Current100 mA – 100 A
PackagesSOD-123, SMA/SMB/SMC, TO-220, TO-247, DO-41/DO-201, stud mount
Key parametersVf, Ir, trr, Vz tolerance, Rth(j-c)
ArraysCommon-cathode and common-anode duals available

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • Buck and boost converters
  • Freewheeling and clamp duty
  • Reverse polarity protection
  • Rectifier bridges in power supplies
  • Signal clamping and reference
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
SS34 MDD SMA 40 V 3 A Schottky 5,000 pcs Seen in market

Questions buyers ask about Diode

Can a Schottky replace a fast recovery diode?

Only below its voltage limit and after checking reverse leakage at temperature. Above roughly 100 V the leakage becomes a real thermal problem, and we will say so rather than fill the line.

Do you quote dual diodes as matched pairs?

Yes, common-cathode and common-anode duals from the same lot where the quantity allows.

Are Zener tolerances exact?

Bins are ±1%, ±2% and ±5%. Tell us which bin the design assumes, because a 5% part in a 1% position shifts the clamp voltage.

More in Power & Discrete

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.