Skip to content

Passives

Crystals & Resonators

SMD and through-hole crystals, ceramic resonators and oscillator modules, quoted with load capacitance and stability tolerance.

Specifying Crystal without a costly substitution

A crystal is only specified when the load capacitance, frequency tolerance and operating temperature range are all stated. The same 16 MHz part in 3.2 × 2.5 mm can be 10 ppm or 30 ppm, 8 pF or 12 pF load, and the wrong load capacitance pulls the frequency enough to break a USB timing margin or a radio channel.

We quote by frequency, package, load capacitance, tolerance over temperature and ESR. For real-time clocks, the 32.768 kHz tuning-fork parts have their own rules — ESR rises steeply and drive level must stay low, so a substitute with a higher ESR can simply fail to start at cold temperature.

Where a design needs a complete oscillator rather than a bare crystal, we quote the packaged oscillator with supply voltage, output logic and stability. Those are usually factory-order lines with a real lead time, unlike commodity crystals which are genuinely shelf stock.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
Packages1612, 2016, 2520, 3225, 5032, HC-49S, cylindrical
Frequency32.768 kHz – 100 MHz (fundamental and 3rd overtone)
Tolerance±10 ppm – ±50 ppm over temperature
Load capacitance6 pF – 20 pF typical, specified per part
ResonatorsCeramic 3-pin, 2-pin, with and without built-in capacitors
OscillatorsSPXO, TCXO, VCXO on request with supply and logic level

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • MCU and SoC clock references
  • USB and Ethernet timing
  • RTC timekeeping
  • RF transceiver reference
  • Consumer audio clocks
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
X49SM8MSD2SC YXC HC-49S 8.000 MHz 20 pF 1,000 pcs Seen in market

Questions buyers ask about Crystal

Which tolerance do I need?

It depends on the protocol budget, not on price. USB full-speed and Ethernet need tighter budgets than a general MCU clock. Tell us the interface and we will flag where 30 ppm is too loose.

Can you match a discontinued crystal?

Usually by frequency and load capacitance, but the ESR and drive level must be checked for 32.768 kHz parts. We will state which parameters are equivalent and which are not.

Are the oscillators in stock?

Generally not — quoted per order with the factory lead time. Commodity crystals and resonators are the parts that are genuinely available from the market.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.