Skip to content

Passives

Varistors & TVS Diodes

Metal-oxide varistors and transient voltage suppressors for surge, ESD and inductive load protection, quoted by clamping voltage and surge rating.

Specifying Varistor / TVS without a costly substitution

Protection parts are the cheapest component on the board until they are chosen by package size. A TVS is defined by its standoff voltage, breakdown voltage, clamping voltage at a specified surge current, and capacitance. Pick one with too low a standoff and it conducts in normal operation; pick one with high capacitance on a data line and the eye diagram collapses.

Varistors are a different trade: they absorb energy and degrade with each surge. The disc diameter sets the energy rating, and a smaller disc in the same voltage class will fail earlier. For mains input protection, the varistor voltage rating must be above the highest sustained line voltage, not just the nominal one.

We quote TVS arrays for interfaces, discrete TVS for power rails and varistors for mains and inductive loads, with the clamping voltage at the specified test current rather than a marketing peak pulse figure. Where an interface needs both a TVS and a common-mode choke, we quote them together so the capacitance budget is considered once.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
TVS typesUnidirectional and bidirectional, discrete and array
Standoff voltage3.3 V – 440 V
PackagesSOD-323, SOD-123, SMA/SMB/SMC, DFN, SO-8 arrays
Varistor5 mm – 20 mm disc, 14 V – 1,000 V RMS class
Key parametersVbr, Vclamp at Ipp, peak pulse power, capacitance
ComplianceAEC-Q101 series available on request

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • ESD protection on USB and HDMI
  • Surge protection on AC input
  • Inductive load flyback clamping
  • RS-485 and CAN bus protection
  • Automotive load dump
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
SMAJ5.0A Littelfuse SMA unidirectional 5 V 5,000 pcs Seen in market

Questions buyers ask about Varistor / TVS

TVS or varistor for mains input?

Varistor for sustained surge energy, TVS for fast transients; many designs use both. The varistor voltage must sit above the maximum line voltage, and the TVS clamp must stay below the downstream rating.

What capacitance is acceptable on a data line?

Depends on the data rate. USB 2.0 has far more budget than USB 3.x or HDMI. Send the interface and we will quote parts that fit the capacitance budget instead of the cheapest SOT-23.

Do you supply AEC-Q101 parts?

Yes, on a per-line basis. Automotive-qualified protection is a narrower market and is confirmed against the approved list before pricing.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.