Skip to content

Passives

Common-Mode Chokes & Ferrite Beads

Common-mode chokes for power and signal lines plus SMD ferrite beads, quoted with impedance at frequency rather than just package size.

Specifying Choke / Bead without a costly substitution

A ferrite bead is a frequency-dependent resistor, and the only number that matters is the impedance at the frequency you are trying to attenuate. Two 0603 beads that both read "600 Ω" can differ by a factor of two at 100 MHz, and one of them will resonate with your decoupling network instead of damping it. Package size alone tells you nothing.

We quote beads by impedance curve, rated current and DC resistance, and common-mode chokes by impedance, current rating, winding type and isolation. For power lines the saturation behaviour under DC bias is the usual failure point: a bead rated 500 mA that is asked to carry 800 mA stops being a filter and becomes a heater.

For USB, HDMI and CAN interfaces, the choke and the ESD protection are usually specified together. We can quote the pair so the impedance and clamping voltage are considered as one filter, which is the only way the result can be predicted before the board is built.

Typical specifications

Ranges we routinely source in this category. They describe the window, not a single part — the exact value is fixed by the datasheet you specify.

ParameterRange we source
Bead sizes0402, 0603, 0805, 1206, 1812
Impedance10 Ω – 3 kΩ at 100 MHz, series dependent
Rated current50 mA – 6 A
Choke typesThrough-hole and SMD, 2-line and 3-line, nanocrystalline cores
Key parametersZ vs frequency, DCR, Irms, isolation voltage
MountingSMD for beads; SMD and radial for chokes

Where it is used

Typical applications we quote for. If your use case needs a tighter parameter than the list suggests, say so at quotation — it changes which suppliers are viable.

  • USB and HDMI common-mode filtering
  • CAN and RS-485 line conditioning
  • Switching supply input filtering
  • Motor cable EMI suppression
  • Sensor line noise rejection
Sourcing note. Availability, lead time and price are confirmed per line item at quotation. This page describes the range we can source — it is not a stock guarantee.

Part numbers on the desk

Specific parts we have looked at recently. Availability is re-confirmed at quotation; the note is what we saw, not a reservation.

Sample data. Sample entries: these rows show the format of the desk while live records are being entered. Availability is illustrative and always re-confirmed at quotation.
Part number Brand Package MOQ Availability
DLW21HN900SQ2L Murata 0805 common-mode choke 90 Ω 2,000 pcs Seen in market

Questions buyers ask about Choke / Bead

Which bead impedance should I choose?

Match the impedance peak to the noise band you are fighting, then check the DC bias derating. We can quote two or three candidates with their curves if you share the frequency of concern.

Do chokes come with certification for mains use?

Certified series exist and are quoted as such. A general-purpose choke used across the mains is a safety question, not a filtering one, so we will not silently substitute.

Can you supply matched bead and TVS pairs?

Yes. Send the interface and the surge level; we quote the pair with the working voltage and clamping behaviour stated.

Next step

Send the part number. We will check the booths.

One line or a full BOM — the answer comes back per line, with the market position stated rather than implied.